氫氧化鉀極易吸收空氣中水分而潮解，吸收二氧化碳而成碳酸鉀。當溶解于水、醇或用酸處理時產生大量熱量。溶于乙醇，微溶于醚。有極強的堿性和腐蝕性，其性質與燒堿相似。但是大家知道它的合成工藝是什么嗎？下面就給大家來講解一下吧。
　　Potassium hydroxide can easily absorb water in air and deliquescence, and absorb carbon dioxide to form potassium carbonate. When dissolved in water, alcohol or treated with acid, it produces a lot of heat. Soluble in ethanol, slightly soluble in ether. It has strong alkalinity and corrosiveness, and its properties are similar to those of caustic soda. But do you know what the synthesis process is? Now let's talk about it.
　　氯化鉀在化鹽槽溶化成飽和溶液，加熱至90℃時分別加入碳酸鉀、苛性鉀、氯化鋇除去鈣、鎂和硫酸根等雜質，經沉降除渣、鹽酸中和、精制的含氯化鉀280～315g／L的氯化鉀溶液經預熱到70～75℃后進行電解，得氫氧化鉀、氯氣和氫氣。隔膜法所得產品濃度為10％～11％，需通過蒸發濃縮和冷卻澄清，制得含45％～50％產品的溶液；也可繼續在熬堿鍋中濃縮，經脫色，制得固體產品，或經制片成片狀產品。其反應式如下：
　　Potassium chloride dissolves into saturated solution in the salt bath. Potassium carbonate, caustic potassium and barium chloride are added to remove impurities such as calcium, magnesium and sulfate at 90 C. Potassium hydroxide, chlorine gas and hydrogen are obtained by electrolysis of refined potassium chloride solution containing 280-315g/L of potassium chloride after precipitation, hydrochloric acid neutralization and preheating to 70-75 C. The concentration of the product obtained by diaphragm method is 10%-11%. The solution containing 45%-50% of the product is prepared by evaporation, concentration and cooling clarification. It can also be concentrated in the boiling pot and decolorized to produce solid products or flake products. The reaction formulas are as follows:

　　2KCl+2H2O[電解]→2KOH+C12↑+H2↑
　　2KCl+2H2[electrolysis]2KOH+C12_+H2_
　　水銀電解法電解液的配制同隔膜電解法。電解室中以石墨(或金屬)作陽極，水銀作陰極，電解產生的氯氣送氯氣干燥工序，生成的鉀汞齊流人解汞室。大部分未反應的氯化鉀以淡鹽水狀態經處理后，返回原料溶解工序。因解汞室出來的濃度為45％～50％，可作為液體產品，也可再經熬堿鍋蒸濃成固堿或制成片狀產品。其電解及鉀汞齊解汞反應式如下：
　　The preparation of electrolyte for mercury electrolysis is the same as that for diaphragm electrolysis. In the electrolysis chamber, graphite (or metal) is used as anode, mercury is used as cathode, chlorine gas from electrolysis is is sent to the chlorine gas drying process, and potassium amalgam is produced in the mercury chamber. Most unreacted potassium chloride is treated in dilute brine and returned to the raw material dissolution process. Because the concentration of mercury solution chamber is 45%-50%, it can be used as a liquid product, or can be steamed and concentrated to solid alkali or made into flake products by boiling soda pot. The reaction formulas of electrolysis and potassium amalgamation for mercury dissolution are as follows:
　　2KCl+2Hg2→2Hg2K+Cl2。
　　2KCl+2Hg2_2Hg2K+Cl2.
　　2KCl+2Hg2-2Hg2K+Cl2。
　　2KCl+2Hg2-2Hg2K+Cl2.
　　2Hg2K+2H2O→2KOH+H2+4Hg。
　　2Hg2K+2H2_2KOH+H2+4Hg.
　　2Hg2K+2H2O-2KOH+H2+4Hg。
　　2Hg2K+2H_2O-2KOH+H2+4Hg.
　　以上就是給大家總結的關于氫氧化鉀的合成工藝，相信大家都已經有所了解了，另外具強堿性及腐蝕性。吸收二氧化碳而成碳酸鉀。0.1mol/L溶液的pH為13.5。白色斜方結晶，工業品為白色或淡灰色的塊狀或棒狀。易溶于水，溶于乙醇，微溶于醚。
　　The above is a summary of the synthesis process of potassium hydroxide, I believe that everyone has already understood, in addition to strong alkalinity and corrosiveness. Absorbing carbon dioxide to form potassium carbonate. The pH of 0.1 mol/L solution is 13.5. White oblique crystal, industrial products for white or light gray block or bar. It is soluble in water, ethanol and ether.
　　如果您有氫氧化鉀的產品需求可以點擊我們的官網進行咨詢：http://www.aoure.cn
　　If you have the demand for potassium hydroxide products, you can click on our website to consult: http://www.aoure.cn.